Global Drivers

Last updated on December 28, The time now is Follow the cautions below when handling a PCU. Make sure that the holes for the screws on the front and rear end of the PCU are aligned correctly. Network Connectivity – Have a MFC that’s lost it’s ability to communicate with the network after about 4 years. Tighten the top screw [F]. See Note in Bold Green above.

Uploader: Mezill
Date Added: 23 April 2008
File Size: 8.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96554
Price: Free* [*Free Regsitration Required]

Aficio MP 2550/2550B/3350/3350B

Remove the front screw [A] x1 5. Set the rear cover and front cover [B]. The time now is Replace the charge roller [E].

I will warn you that it will most likely get messy. Details vBulletin Mods by vBSocial.

Attached is a 3 page pdf of the settings and their values. Make sure that all of the holes and tabs on are engaged at [A], [B], and [C].

Tighten the three screws and coupling [D]. I have pulled the controller board marked “Ricoh” and “D” read here that one guy replaced the board and still had no communications as well as an error code Currently the machine is not showing any. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations.

  KWORLD TV878 VIDEO CAPTURE DRIVER DOWNLOAD

Open the right cover [A] and front cover [B]. Separate the top [E] and bottom [F] of the development unit. The drum unit is photo conductive. Turn on the main power switch.

Remove the PCU from the machine. Network Connectivity – Have a MFC that’s lost it’s ability to communicate with the network after about 4 years. Turn the development roller gear [I] to remove toner from around the development roller.

Results 1 to 1 of 1. Tighten the lower screw [E]. Remove the rear shoulder screw ld245 x1.

Tags for this Thread addresscablemachinenetworksettings. Set the bottom on the vinyl sheet.

D0193501 Ricoh Aficio MP 2550 Toner Supply Unit

Lwnier on the main power switch, and close the front door. See Note in Bold Green above. I don’t mind loosing everything but the counters.

Release the front tab [C]. Yes, I know i’ve got to clean up that line on the output as well. Remove the front stud [A]. Make sure that the head of the stud is put in the correct position. You ld25 be logged in to post a comment.

  CCU-550 EVDO USB MODEM DRIVER DOWNLOAD

Printer: Lanier MP /LD | OpenPrinting – The Linux Foundation

Attach the side screw [G]. If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly. Install the PCU in the machine. Make sure that the holes for the screws on the front and rear end of the PCU are aligned correctly.